jonathan.h8 – Activité

Notifications

Clear all

jonathan.h8

Groupe: Enregistré

A(ont) rejoint: 2017/09/24

Trusted Member

	Cool! Think i can stream on both at the same time. Dans le forum Others (Archive)	il y a 7 years
	I think you are misunderstanding why I am using the dragon a... Dans le forum Others (Archive)	il y a 7 years
	The warping is mostly due to layer contraction, the upper la... Dans le forum Others (Archive)	il y a 7 years
	The dragon is printing fine. So it must be slicr settings. Dans le forum Others (Archive)	il y a 7 years
	Hi, I don’t believe it’s due to drafts. This rooms very smal... Dans le forum Others (Archive)	il y a 7 years
	Print Warping: Dans le forum Others (Archive)	il y a 7 years
	Now that the live feed is off, here are the resulting videos... Dans le forum Others (Archive)	il y a 7 years
	Managed to get the lime green filament to work okay Dans le forum Others (Archive)	il y a 7 years
	I have had false filament out instances with a darker green ... Dans le forum Others (Archive)	il y a 7 years
	Have you read the manual? It states that lime green filament... Dans le forum Others (Archive)	il y a 7 years
	Autoload Not Working: Lime Green Filament Dans le forum Others (Archive)	il y a 7 years
	Thanks Joan, I'll keep an eye out for that. Perhaps that is... Dans le forum Others (Archive)	il y a 7 years
	Loving my MK3 - Printing Live on Youtube! Dans le forum Others (Archive)	il y a 7 years
	Thanks Joan, I will do. At the beginning, I fell like it’s b... Dans le forum Print tips (Archive)	il y a 7 years
	I am happy to report that I have not since experienced any c... Dans le forum Others (Archive)	il y a 7 years
	These are the parts i'm trying to print at the moment. As ... Dans le forum Others (Archive)	il y a 7 years
	Thanks for both replies! I'll give it a try. I am trying t... Dans le forum Others (Archive)	il y a 7 years
	I didn't quite make the leap in the end. I thought it best ... Dans le forum Print tips (Archive)	il y a 7 years
	Rigid ink qnd filamentive are both good. Joan Thanks! Dans le forum Print tips (Archive)	il y a 7 years
	Recommended UK Based Filament Supplier: Dans le forum Print tips (Archive)	il y a 7 years

Page 2 / 3 Précédent Suivant

Statistiques du forum

559 Forums

62.9 K Sujets

443 K Messages

21 En-ligne

67.7 K Membres

Le dernier des messages: MK4S Ständig Festsitzendes PLA Notre nouveau membre: pinklemonade Messages récents Messages non lus Balises

Icones du forum: Le forum ne contient pas de messages non lus Le forum contient des messages non lus

Icones du sujet: Sans réponse Repondu Actifs Au top Épinglé Non approuvé Résolu Privé Fermé