Prusa3D Forum

Notifications

Clear all

JollyBob

Groupe: Enregistré

A(ont) rejoint: 2017/02/13

Active Member

	Yeah. Me too. I thought homing set the nozzle to zero but th... Dans le forum Hardware, firmware and software help	il y a 5 years
	Longshot: what if you would increase the pinda-nozzle value ... Dans le forum Hardware, firmware and software help	il y a 5 years
	@ian-s3 That would be a nice update/bugfix from Prusa I thin... Dans le forum Hardware, firmware and software help	il y a 5 years
	@ian-s3 So if you edit the pinda mount and print a new part ... Dans le forum Hardware, firmware and software help	il y a 5 years
	I see the logic in this, problem is that I dont see anything... Dans le forum Hardware, firmware and software help	il y a 5 years
	I have this exact problem. Never had to use the full bed bef... Dans le forum Hardware, firmware and software help	il y a 5 years
	I just had this today. I lowered the probe a tiny bit. Worke... Dans le forum Prusa i3 kit (Archive)	il y a 8 years
	When I got that with my first big print I was a bit upset to... Dans le forum Prusa i3 kit (Archive)	il y a 8 years

Statistiques du forum

565 Forums

64.5 K Sujets

451.8 K Messages

25 En-ligne

71.1 K Membres

Icones du forum: Le forum ne contient pas de messages non lus Le forum contient des messages non lus

Icones du sujet: Sans réponse Repondu Actifs Au top Épinglé Non approuvé Résolu Privé Fermé