Notifications
Clear all
johnnyruz
johnnyruz
Group: Registered
Joined: 2017/04/28
Active Member
1
I'm so thankful I found this thread!! My MMU2S arrived 2 wee...

In forum Hardware, firmware and software help

5 years ago
Thanks for sharing this. I've done the same thing with a pie...

In forum Hardware, firmware and software help

6 years ago
I've been participating in The Spaghetti Detective BETA for ...

In forum User mods - OctoPrint, enclosures, nozzles, ...

6 years ago
I tested the 7x7 MBL with 5 points and mag compensation on l...

In forum General discussion, announcements and releases

6 years ago
When printing flexible material, I prep my bed with a very f...

In forum Hardware, firmware and software help

6 years ago
I'm not sure if this is the correct place to post this or if...

In forum General discussion, announcements and releases

6 years ago
I've printed PLA, PETG, and Flex on my textured bed (mk2.5 u...

In forum Hardware, firmware and software help

6 years ago
Not sure about the IGUS bearings, but I had the same issue w...

In forum Assembly and first prints troubleshooting

6 years ago
Just got shipping notice for my 2.5 upgrade (powder coated) ...

In forum General discussion, announcements and releases

6 years ago
I just replaced my PEI sheet about a week ago and while I'm ...

In forum Others (Archive)

7 years ago
I'm also looking forward to them releasing information about...

In forum Others (Archive)

7 years ago
Nevermind I found it, it's a new addition to 3.0.12 RC firmw...

In forum Prusa i3 kit (Archive)

7 years ago
So I finished assembling the MK2S kit a few days ago and hav...

In forum Prusa i3 kit (Archive)

7 years ago
Update on my Orange/Black KIT Ordered April 28th Tracking N...

In forum General discussion, announcements and releases

7 years ago
Check this thread:

In forum Prusa i3 kit (Archive)

7 years ago
Got my "In Transit" e-mail and tracking number earlier today...

In forum General discussion, announcements and releases

7 years ago
Increasing the production of fully assembled by 20 a day is ...

In forum General discussion, announcements and releases

7 years ago
Congrats to you guys with printers on the way or received! G...

In forum General discussion, announcements and releases

8 years ago
Hello all! I ordered my black/orange kit on April 28th and ...

In forum General discussion, announcements and releases

8 years ago
Share: