Prusa3D Forum

Notifications

Clear all

johnny.y

Groupe: Enregistré

A(ont) rejoint: 2016/08/05

Active Member

	Bringing this back from the dead. This just happened to me.... Dans le forum Others (Archive)	il y a 8 years
	I guess I can join the club of having the hotend crash into ... Dans le forum Others (Archive)	il y a 8 years
	I was actually having this issue too. I thought I was the o... Dans le forum Prusa i3 kit (Archive)	il y a 8 years
	The zits issue happens for me too. I was able to somewhat m... Dans le forum General discussion, announcements and releases	il y a 8 years
	Ok I did a combination of things. First I tried adjusting d... Dans le forum Prusa i3 kit (Archive)	il y a 8 years
	Gaps in the first layer when printing ABS Dans le forum Prusa i3 kit (Archive)	il y a 8 years
	Here you go. Maybe it's a seam. Fixable? Or maybe sandpap... Dans le forum How do I print this? (Printing help)	il y a 8 years
	Cylinder prints surface on PLA, blobs or rough Dans le forum How do I print this? (Printing help)	il y a 8 years
	Hi, I'm not sure it's been discussed but I can't print over... Dans le forum General discussion, announcements and releases	il y a 8 years

Statistiques du forum

565 Forums

64.1 K Sujets

449.3 K Messages

19 En-ligne

70.3 K Membres

Icones du forum: Le forum ne contient pas de messages non lus Le forum contient des messages non lus

Icones du sujet: Sans réponse Repondu Actifs Au top Épinglé Non approuvé Résolu Privé Fermé