Prusa3D Forum

Notifications

Clear all

JohnC

Grupa: Zarejestrowany

Dołączył: 2016/09/27

Active Member

	@vojtech-bubnik I found a couple of issues for appimage comp... In forum PrusaSlicer	4 years temu
	@gadgetman See the much simpler installation method using Fl... In forum PrusaSlicer	4 years temu
	Update: I found a much much simpler way of installing and us... In forum PrusaSlicer	4 years temu
	Thanks so much for exploring supporting Chromebooks, there a... In forum PrusaSlicer	4 years temu
	I recently got an error saying '/tmp/.mount_PrusaSr9xlJx/usr... In forum PrusaSlicer	5 years temu
	My mistake, to run it again you have to do steps 6+7, just r... In forum PrusaSlicer	5 years temu
	OK, I got it to work by adapting these instructions so here... In forum PrusaSlicer	5 years temu
	I understand it is possible to just double click to run .deb... In forum PrusaSlicer	5 years temu
	How to install and run PrusaSlicer on Chromebook with Linux ... In forum PrusaSlicer	5 years temu
	Unload filament command works below safe temperature to unlo... In forum Others (Archive)	8 years temu
	I started a issue on the Cura Github repository for this pro... In forum General discussion, announcements and releases	8 years temu

Statystyki Forum

565 Fora

63.7 K Tematy

446.7 K Posty

20 Online

69.2 K Członkowie

Forum Icons: Forum contains no unread posts Forum contains unread posts

Ikony tematu: Not Replied Odwpowiedzi Aktywny Gorący Przyklejony Unapproved Rozwiązany Private Zamknięte