Prusa3D Forum

Notifications

Clear all

john.p24

Skupina: Registrovaný

Přidal se: 2017/10/25

Active Member

	Adding to the list of thermistor problems In forum Hardware, firmware and software help	před 6 years
	clean the bed with 90% rubbing alcohol then redo your live z... In forum How do I print this? (Printing help)	před 7 years
	I got the V2 calibration gcode and ran that. It seemed like ... In forum How do I print this? (Printing help)	před 7 years
	This is the first layer test results. At the beginning was s... In forum How do I print this? (Printing help)	před 7 years
	I don't know what to make of it. This was working absolutely... In forum How do I print this? (Printing help)	před 7 years
	Also I didn't realize that this was just a steal plate and n... In forum How do I print this? (Printing help)	před 7 years
	Assembled Mk3 after a month suddenly prints a mess In forum How do I print this? (Printing help)	před 7 years
	I cranked it up to 240 and I had to use an allen wrench that... In forum Hardware, firmware and software help	před 7 years
	I tried preheating it the nozzle to 215 and then 220, but ne... In forum Hardware, firmware and software help	před 7 years
	I've been shoving as hard as I can with filament to hope to ... In forum Hardware, firmware and software help	před 7 years
	There are detailed guides to assembling a car but without th... In forum Hardware, firmware and software help	před 7 years
	Third Print - ruined the teflon tube In forum Hardware, firmware and software help	před 7 years
	Third Print - ruined the teflon tube In forum Hardware, firmware and software help	před 7 years

Fórum Statistiky

566 Fóra

63.2 K Témata

444.3 K Příspěvky

19 Online

68.1 K Uživatelé

Forum Icons: Forum contains no unread posts Forum contains unread posts

Topic Icons: Not Replied Replied Active Hot Sticky Unapproved Solved Private Closed