Aktywność
 
Notifications
Clear all
John Doe
John Doe
Grupa: Zarejestrowany
Dołączył: 2017/05/06
Active Member
1
Ok thanks

In forum Assembly and first prints troubleshooting

6 years temu
Thanks. I think ive settled on this starting GCODE M115 U3...

In forum Assembly and first prints troubleshooting

6 years temu
Also are you using the stock starting and ending GCODE or a ...

In forum Assembly and first prints troubleshooting

6 years temu
Thanks, I understand you are doing this in your spare time a...

In forum Assembly and first prints troubleshooting

6 years temu
Hi, I've been out of the loop for a while but just recently ...

In forum Assembly and first prints troubleshooting

6 years temu
Hi, I've been out of the loop for a while but just recently ...

In forum Assembly and first prints troubleshooting

6 years temu
So i'm at my witts end right now, i've never had any problem...

In forum Assembly and first prints troubleshooting

7 years temu
I was wondering if it would be too much of a hassle to uploa...

In forum Assembly and first prints troubleshooting

7 years temu
will the G80 command override all of the set numbers in the ...

In forum Assembly and first prints troubleshooting

7 years temu
Thanks jeffjordan, appreciate your work. Unfortunately I thi...

In forum Assembly and first prints troubleshooting

7 years temu
Try a different camera and/or cable. Peter I've tried 3 r...

In forum Others (Archive)

7 years temu
Did you enable the camera in the main raspberry pi setup men...

In forum Others (Archive)

7 years temu
Tried that, still nothing. I can confirm the changes were ma...

In forum Others (Archive)

7 years temu
Unfortunately I've tried 3 ribbon cables and 2 cams no joy.

In forum Others (Archive)

7 years temu
Pi 3, Pi Cam V2, Octoprint HELP

In forum Others (Archive)

7 years temu
Share: