Activity
 
Notifications
Clear all
John
John
Group: Registered
Joined: 2018/08/20
Reputable Member
5
If you are bridging, you need to check the sliced model to e...

In forum General discussion, announcements and releases

2 months ago
When I suggested pulling the nut in with the screw I mean do...

In forum General discussion, announcements and releases

2 months ago
@Tango - I think you are over thinking this. If they are pul...

In forum General discussion, announcements and releases

2 months ago
If you make the recess just too tight to be able to press th...

In forum General discussion, announcements and releases

2 months ago
You could always just use a standard nut pressed in from the...

In forum General discussion, announcements and releases

2 months ago
Actually on my mk3 I had a layer shift of about 20 mm half w...

In forum Input Shaper (MK4)

2 months ago
Hi I am updating my print profile and it now asks for what n...

In forum General discussion, announcements and releases

3 months ago
good to know

In forum PrusaSlicer

6 months ago
to be honest I didn't think what printer it was o, but I don...

In forum Input Shaper (MK4)

6 months ago
I got the impression the Op wants to orient the honeycomb si...

In forum PrusaSlicer

6 months ago
I had an issue where I was suddenly getting elephant foot an...

In forum Input Shaper (MK4)

6 months ago
Also gyroid will print a fill more suited to z-axis strength

In forum PrusaSlicer

6 months ago
Consider cubic which I believe will add strength in the zaxi...

In forum PrusaSlicer

6 months ago
I second the Prusa PA sheet.

In forum How do I print this? (Printing help)

6 months ago
I would have thought that if wires are touching they would h...

In forum Hardware, firmware and software help

7 months ago
I should have expressed my question after doing some researc...

In forum General discussion, announcements and releases

7 months ago
What device are you using to extract the air?

In forum General discussion, announcements and releases

7 months ago
One think I notice is the image in the OP link shows the hop...

In forum How do I print this? (Printing help)

8 months ago
Yes just the slither at the top at 0.15 - I was trying to av...

In forum PrusaSlicer

11 months ago
sorry for confusion Im not sure the 3mf file would help but ...

In forum PrusaSlicer

11 months ago
Page 2 / 19
Share: