Prusa3D Forum

Notifications

Clear all

joe.m4

Groupe: Enregistré

A(ont) rejoint: 2016/11/01

Active Member

	Did you ever get this resolved? I just finished my MK4S upg... Dans le forum Hardware, firmware and software help	il y a 2 months
	Printer mostly OFFLINE after upgrade of MK4 to MK4S Dans le forum Bugs & Errors	il y a 2 months
	@grnarledcardboard, I'm just curious, are you on a Mac as we... Dans le forum Bugs & Errors	il y a 5 months
	Yes, I mentioned in my original post that I deleted all site... Dans le forum Bugs & Errors	il y a 5 months
	UPDATE: I got it to work but... it's a terrible workaroun... Dans le forum Bugs & Errors	il y a 5 months
	Uploads to Prusa Connect not working Dans le forum Bugs & Errors	il y a 5 months
	Yes, I just grabbed 0.6.1 because that is the latest release... Dans le forum Bugs & Errors	il y a 2 years
	I have tried following these workaround steps and I am able ... Dans le forum Bugs & Errors	il y a 2 years
	Sage advice and something I have already started doing since... Dans le forum PrusaSlicer	il y a 3 years
	Is it possible to add supports to an existing gcode file? Dans le forum PrusaSlicer	il y a 3 years
	Did you find a solution to this? I ordered an assembled MK2... Dans le forum Prusa i3 kit (Archive)	il y a 8 years
	About to start the same build. Just starting into 3D printin... Dans le forum Awesome prints (Hall Of Fame)	il y a 8 years

Statistiques du forum

559 Forums

63.1 K Sujets

443.8 K Messages

20 En-ligne

68 K Membres

Icones du forum: Le forum ne contient pas de messages non lus Le forum contient des messages non lus

Icones du sujet: Sans réponse Repondu Actifs Au top Épinglé Non approuvé Résolu Privé Fermé