Notifications
Clear all
Joe
Skupina: Registrovaný
Přidal se: 2022/11/02
Active Member
1
| Yes, that is the issue. Thanks for pointing that out. | před 9 months | |
| It appears my problem has been solved. When switching compu... | před 9 months | |
| Here is the next print but this time sliced with Prusa slice... | před 10 months | |
| Radial Layer Shifts randomly in Z, two different i3MK3 print... | před 10 months | |
| It didn't seem like a mechanical because I was able to print... | před 2 years | |
| I just printed a small part and it printed just fine. | před 2 years | |
| Thermal Runaway, after about 5 minutes of printing | před 2 years |