Deutsch
Foren
Mitglieder
JoanTabb
Aktivität
 
Benachrichtigungen
Alles löschen
JoanTabb
JoanTabb
Gruppe: Moderator
Beigetreten: 2015/10/30
Titel: Veteran Member Moderator
Profil Aktivität
I use the knob on the control panel Regards Joan

Im Forum Others (Archive)

 Vor 9 years
I am pleased for you Eliot, my last print of a benchy di...

Im Forum Prusa i3 kit (Archive)

 Vor 9 years
Hi Peter, do you use a full length of PtFE from the spool ...

Im Forum Others (Archive)

 Vor 9 years
Hi Mat, the Y axis frame is intended to be located 100 mm ...

Im Forum Prusa i3 kit (Archive)

 Vor 9 years
Maintaining Z axis power is intended to reduce the probabili...

Im Forum Others (Archive)

 Vor 9 years
The fan doesnt normally run on the first layer Try a pla de...

Im Forum Prusa i3 kit (Archive)

 Vor 9 years
Hi Elliot, on the Y axis your bearings are constrained by t...

Im Forum Prusa i3 kit (Archive)

 Vor 9 years
put a cork tile underneath the heat bed! regards Joan

Im Forum Prusa i3 kit (Archive)

 Vor 9 years
Hi Kimmo. The idler is a shouldered aluminium sleeve runni...

Im Forum Prusa i3 kit (Archive)

 Vor 9 years
have you tried silent mode? it uses lower power on the step...

Im Forum Others (Archive)

 Vor 9 years
the old heatbreak tube has different dimensions to the MMU o...

Im Forum Others (Archive)

 Vor 9 years
I believe the minimum supported first layer height is 0.15 m...

Im Forum Print tips (Archive)

 Vor 9 years
Have you tried it 5 or 10 degrees hotter? your temperature ...

Im Forum Print tips (Archive)

 Vor 9 years
Is there any reason why you didn't go for first layer height...

Im Forum Print tips (Archive)

 Vor 9 years
My selftest also pulsed the fan motor, as it was spinning,...

Im Forum Prusa i3 kit (Archive)

 Vor 9 years
Did you also calibrate the Live Z height... ? if not, the e...

Im Forum Others (Archive)

 Vor 9 years
if the hot end is still above 50C you might have issues with...

Im Forum Others (Archive)

 Vor 9 years
you can use a modifier mesh in Slic3r regards Joan

Im Forum Others (Archive)

 Vor 9 years
Hi Julien, the Prusa Mk2 and Mk2S both work best with small...

Im Forum Prusa i3 kit (Archive)

 Vor 9 years
Hi Damian the reason Prusa Research specified the Mini Rambo...

Im Forum Prusa i3 kit (Archive)

 Vor 9 years
Seite 524 / 550
Teilen: