Actividad
 
Avisos
Vaciar todo
jmone
jmone
Grupo: Registrado
Registrado: 2018/11/23
Reputable Member
5
Sorry for the late replay, I missed you post! I have a rang...

En el foro PrusaSlicer

hace 3 years
Software to Extrude Down a 2D image with a Draft?

En el foro General software discussion

hace 3 years
No problems, it's all about the community helping each other...

En el foro PrusaSlicer

hace 3 years
The model printed well (I did not use supports, brims etc) a...

En el foro PrusaSlicer

hace 3 years
I've got your sample and I'm currently printing the Right Ca...

En el foro PrusaSlicer

hace 3 years
...actually, I'm not sure this will help as I had a look at ...

En el foro PrusaSlicer

hace 3 years
...if you post the STL, I'll print it on my setup and if it ...

En el foro PrusaSlicer

hace 3 years
Are the skipped layers always in the same place or is it ran...

En el foro PrusaSlicer

hace 3 years
I ran a multi month experiment (the thread is somewhere on t...

En el foro PrusaSlicer

hace 3 years
Doubt it. It really is very easy to print when fully dry. ...

En el foro PrusaSlicer

hace 3 years
I've printed many spools of ePA-CF (all eSun) and all I can ...

En el foro PrusaSlicer

hace 3 years
I'm not familiar with this brand of PA-CF but 8h in a Food D...

En el foro PrusaSlicer

hace 3 years
Sounds good

En el foro PrusaSlicer

hace 3 years
Good you have the dimensions down and working. I find that w...

En el foro PrusaSlicer

hace 3 years
@ffdez. There is a little Lock Icon in the scale factor, if...

En el foro PrusaSlicer

hace 3 years
@ffdez Couple of other things that may impact it: - I keep m...

En el foro PrusaSlicer

hace 3 years
I found this info on shrinkage for Injection Moulding and PA...

En el foro PrusaSlicer

hace 3 years
Print looks pretty good. I've not noticed issue with dimens...

En el foro PrusaSlicer

hace 3 years
@ffdez Here you go (exported 3MF model)... FWIW, my setup al...

En el foro PrusaSlicer

hace 3 years
My setup is MM3s/MMU2s + Mosquito Magnum + High Temp Thermis...

En el foro User mods - OctoPrint, enclosures, nozzles, ...

hace 4 years
Página 2 / 18
Compartir: