Attività
 
Notifiche
Cancella tutti
jimD
jimD
Gruppo: Registrato
Registrato: 2020/10/02
Trusted Member
3
The overhang was why I added the supports. As I said previo...

Nel forum How do I print this? (Printing help)

3 years fa
Thanks for the suggestion. I removed the supports and it di...

Nel forum How do I print this? (Printing help)

3 years fa
Attached is the view after it was sliced. What was showing b...

Nel forum How do I print this? (Printing help)

3 years fa
I zipped the .3mf from slicer and attached it.  Sole-...

Nel forum How do I print this? (Printing help)

3 years fa
I zipped the .3mf from slicer and attached it.  Sole-...

Nel forum How do I print this? (Printing help)

3 years fa
Very poor print quality on underside of ABS even with suppor...

Nel forum How do I print this? (Printing help)

3 years fa
Thanks, I finally heard back from the forum admin. They said...

Nel forum Assembly and first prints troubleshooting

3 years fa
How do I reach a forum admin to see if my id is blocked fro...

Nel forum Assembly and first prints troubleshooting

3 years fa
Not sure what I'm doing wrong. I've attached a zip of the 3m...

Nel forum Assembly and first prints troubleshooting

3 years fa
last try didn't save

Nel forum Assembly and first prints troubleshooting

3 years fa
Here is the zip of the 3mf file for the abs version.

Nel forum Assembly and first prints troubleshooting

3 years fa
Only on one side. It looks like it is 45 deg between the re...

Nel forum Assembly and first prints troubleshooting

3 years fa
what is causing this defect in both abs and pla prints on a ...

Nel forum Assembly and first prints troubleshooting

3 years fa
close this out. Turned out to be a bad caliper. I used anoth...

Nel forum PrusaSlicer

3 years fa
printing at wrong size from Fusion 360

Nel forum PrusaSlicer

3 years fa
problem on startup MK3S

Nel forum Hardware, firmware and software help

4 years fa
Pagina 3 / 3
Condividi: