Activité
 
Notifications
Clear all
jimD
jimD
Groupe: Enregistré
A(ont) rejoint: 2020/10/02
Trusted Member
3
The overhang was why I added the supports. As I said previo...

Dans le forum How do I print this? (Printing help)

il y a 3 years
Thanks for the suggestion. I removed the supports and it di...

Dans le forum How do I print this? (Printing help)

il y a 3 years
Attached is the view after it was sliced. What was showing b...

Dans le forum How do I print this? (Printing help)

il y a 3 years
I zipped the .3mf from slicer and attached it.  Sole-...

Dans le forum How do I print this? (Printing help)

il y a 3 years
I zipped the .3mf from slicer and attached it.  Sole-...

Dans le forum How do I print this? (Printing help)

il y a 3 years
Very poor print quality on underside of ABS even with suppor...

Dans le forum How do I print this? (Printing help)

il y a 3 years
Thanks, I finally heard back from the forum admin. They said...

Dans le forum Assembly and first prints troubleshooting

il y a 3 years
How do I reach a forum admin to see if my id is blocked fro...

Dans le forum Assembly and first prints troubleshooting

il y a 3 years
Not sure what I'm doing wrong. I've attached a zip of the 3m...

Dans le forum Assembly and first prints troubleshooting

il y a 3 years
last try didn't save

Dans le forum Assembly and first prints troubleshooting

il y a 3 years
Here is the zip of the 3mf file for the abs version.

Dans le forum Assembly and first prints troubleshooting

il y a 3 years
Only on one side. It looks like it is 45 deg between the re...

Dans le forum Assembly and first prints troubleshooting

il y a 3 years
what is causing this defect in both abs and pla prints on a ...

Dans le forum Assembly and first prints troubleshooting

il y a 3 years
close this out. Turned out to be a bad caliper. I used anoth...

Dans le forum PrusaSlicer

il y a 3 years
printing at wrong size from Fusion 360

Dans le forum PrusaSlicer

il y a 3 years
problem on startup MK3S

Dans le forum Hardware, firmware and software help

il y a 4 years
Page 3 / 3
Partager :