Prusa3D Forum

Notifications

Clear all

Jim Schrempp

Groupe: Enregistré

A(ont) rejoint: 2022/06/25

Active Member

	Thanks for the ideas. In the 3.5 there is no 0.3mm draft set... Dans le forum How do I print this? (Printing help)	il y a 3 days
	Yes, that is correct. I modified the layer height to be 0.3 ... Dans le forum How do I print this? (Printing help)	il y a 4 days
	Oh, does this forum software silently fail if the file is no... Dans le forum How do I print this? (Printing help)	il y a 4 days
	Hmmm. I did attach it to my post. I'll do it again to this r... Dans le forum How do I print this? (Printing help)	il y a 4 days
	Odd failure on top level; diagonal stripe of loose filament Dans le forum How do I print this? (Printing help)	il y a 5 days
	A friend says this, "The large color swatch is the filament ... Dans le forum PrusaSlicer	il y a 2 weeks
	Thank you. That is good but it doesn't talk about the second... Dans le forum PrusaSlicer	il y a 2 weeks
	MMU filament settings UI documentation - what do the little ... Dans le forum PrusaSlicer	il y a 2 weeks
	thanks. done. Dans le forum PrusaSlicer	il y a 9 months
	You mean to do this after the print is done and removed? Dans le forum PrusaSlicer	il y a 9 months
	Arrange feature should consider organic support footprint Dans le forum PrusaSlicer	il y a 9 months
	Organic footpads could be thicker Dans le forum PrusaSlicer	il y a 9 months
	I tried your suggestion but it did not work. Holding the fil... Dans le forum How do I print this? (Printing help)	il y a 3 years
	Why second purge on filament change during print? Dans le forum How do I print this? (Printing help)	il y a 3 years

Statistiques du forum

567 Forums

65 K Sujets

454.6 K Messages

22 En-ligne

71.9 K Membres

Le dernier des messages: Underextrusion issues with speed! Notre nouveau membre: hattz Messages récents Messages non lus Balises

Icones du forum: Le forum ne contient pas de messages non lus Le forum contient des messages non lus

Icones du sujet: Sans réponse Repondu Actifs Au top Épinglé Non approuvé Résolu Privé Fermé