Notifications
Clear all
Jim Ruxton
Skupina: Registrovaný
Přidal se: 2022/10/30
Active Member
1
| Ok, thanks everyone. All is working well now. The cold pull ... | před 2 years | |
| I took a photo of the extrudes gears and they look correct.T... | před 2 years | |
| I tried tightening the idler screw a bit more and now there ... | před 2 years | |
| Thanks I tried the cold pull. I don't hear any clicking now ... | před 2 years | |
| Trouble with clicking Extruder | před 2 years | |
| Just to finish off this thread in case anyone else finds it.... | před 2 years | |
| Thanks for the feedback. Yes same sheet and nozzle. I change... | před 2 years | |
| Or, should I turn up fan speed? | před 2 years | |
| Print is a little squished using PETG | před 2 years | |
|
Thanks for the great suggestion. I don't use Octoprint but j... In forum Hardware, firmware and software help |
před 2 years | |
|
And things went from bad to worse. After I removed the bad ... In forum Hardware, firmware and software help |
před 2 years | |
|
Removing a part while printing? In forum Hardware, firmware and software help |
před 2 years |