Notifications
Clear all
Jessie31
Skupina: Registrovaný
Přidal se: 2016/10/28
Active Member
1
| Hyperfine bed leveling save my large prints : waldemar.g ,... | před 7 years | |
| I eventually solved the problem. As suggested by robin.a, ... | před 7 years | |
| My PLA Z offset is -0.442. For this PETG, I adjusted up to... | před 7 years | |
| I thought I should flip over the plater to use the unused si... | před 7 years | |
| I had the same Problem with a 250mmx150mm Print. The first "... | před 7 years | |
| Here the unexpected result of mirroring the part or making i... | před 7 years | |
| could try it with the part rotated around z about 30 degrees... | před 7 years | |
| Then I increased the first layer height to 0.35 : ... | před 7 years | |
| I decided to start over the print and the result is visible... | před 7 years | |
| More a Slicr3 issue than an extruder problem ? | před 7 years | |
|
After many attempts I observed that the belt on the left of ... In forum Prusa i3 kit (Archive) |
před 9 years | |
|
Random XYZ calibration outcome In forum Prusa i3 kit (Archive) |
před 9 years |