Activity
 
Notifications
Clear all
Jens
Jens
Group: Registered
Joined: 2016/06/03
Eminent Member
2
Hi and sorry for the delay. Here some pictures first the F...

In forum Others (Archive)

8 years ago
I forgot the second part of the last question ... The auto-...

In forum Others (Archive)

8 years ago
With the PEI I had scratches on the surface. Nothing really ...

In forum Others (Archive)

8 years ago
For sure. But it can be tomorrow though ... Since I need no ...

In forum Others (Archive)

8 years ago
Hi all, I do not like the PEI either. First and foremost, ...

In forum Others (Archive)

8 years ago
sorry, I'm a bit late. I received my kit last summer direct...

In forum Others (Archive)

8 years ago
Yesterday I further tried to remove the parts. I put the bed...

In forum Others (Archive)

8 years ago
Ah ok, I see it now. So I should clean the bed with window c...

In forum Others (Archive)

8 years ago
Patrik I have tried already with different temperatures. No...

In forum Others (Archive)

8 years ago
Vojtěch I know, I dont't blame you. No worries, I had to tr...

In forum Others (Archive)

8 years ago
Print bed ruined by printing ASA-X

In forum Others (Archive)

8 years ago
Hi Manuel The surface also does not indicate too low z-heig...

In forum Prusa i3 kit (Archive)

8 years ago
Hi Manuel The surface looks good, apart from the scratches ...

In forum Prusa i3 kit (Archive)

8 years ago
Eli In most cases it's the z-Height. Could you provide us ...

In forum Prusa i3 kit (Archive)

8 years ago
I have puzzled over what can cause the behavior. Since the ...

In forum Prusa i3 kit (Archive)

8 years ago
Possibly this video series helps. There are compared Slic3r,...

In forum Others (Archive)

8 years ago
I have designed and printed a replacement for the Spool Hold...

In forum Others (Archive)

8 years ago
I'm a little busy at my job at the moment, sorry. Only a fe...

In forum Prusa i3 kit (Archive)

8 years ago
Possibly is the question somewhat inaccurate. I have sever...

In forum Prusa i3 kit (Archive)

8 years ago
How to calibrate geometry of printed parts?

In forum Prusa i3 kit (Archive)

8 years ago
Page 1 / 2
Share: