Notifications
Clear all
jeffkahn72
Skupina: Registrovaný
Přidal se: 2022/01/27
Active Member
1
| Benchy Print Issue | před 2 years | |
|
Thanks to everyone for the help. I ordered some new wire fro... In forum Hardware, firmware and software help |
před 3 years | |
|
I assume this wire is the culprit. Is this easy to replace? ... In forum Hardware, firmware and software help |
před 3 years | |
|
Bed Thermal Runaway In forum Hardware, firmware and software help |
před 3 years | |
|
Wavy or Sliding Edges/Layers In forum Hardware, firmware and software help |
před 3 years | |
| Spoke too soon. Had 5-6 perfect prints and now it is messing... | před 3 years | |
| Redid the Grub Screws and problem solved! Thank you! | před 3 years | |
| I tried tightening the X axis the easy way and then printed ... | před 3 years | |
| Sliding(?) while printing | před 3 years | |
| Thanks for the advice. One update, I changed the nozzle and ... | před 3 years | |
| Should I just give up? | před 3 years | |
| This was super helpful, thank you! I was definitely able to ... | před 4 years | |
| Help with First Layer (Newb) | před 4 years |