|
The scrren parts worked but were different from what was sho... In forum General discussion, announcements and releases |
12 months temu |
|
Bad Parts? In forum General discussion, announcements and releases |
12 months temu |
|
When I went on the other day looking for the extra parts I s... In forum General discussion, announcements and releases |
1 year temu |
|
Thank you all - parts ordered In forum General discussion, announcements and releases |
1 year temu |
|
I already have the kit, I just need the heat bed and power s... In forum General discussion, announcements and releases |
1 year temu |
|
Where do I go to order them? I was just on live chat, down ... In forum General discussion, announcements and releases |
1 year temu |
|
When I ordered my 3.5 upgrade kit I did not see the addition... In forum General discussion, announcements and releases |
1 year temu |
|
Thanks! Yes, according to what I read on their site, it was... In forum General discussion, announcements and releases |
2 years temu |
|
JSW - care to comment on my above? (sorry Red) In forum General discussion, announcements and releases |
2 years temu |
|
I just read the FAQ on layerneer - it says some smooth PEI s... In forum General discussion, announcements and releases |
2 years temu |
|
Red, I'm about to order some (adhesion problem is gone and I... In forum General discussion, announcements and releases |
2 years temu |
|
Thanks Red In forum General discussion, announcements and releases |
2 years temu |
|
I had not heard of layerneer (Bed Weld) before - just looked... In forum General discussion, announcements and releases |
2 years temu |
|
Thanks, Red - I got a pretty good result above, I think it i... In forum General discussion, announcements and releases |
2 years temu |
|
benchy image
IMG_20230306_163820618_HDR.jpg In forum General discussion, announcements and releases |
2 years temu |
|
played around with live Z and got the attached 3X3 print, I ... In forum General discussion, announcements and releases |
2 years temu |
|
Thank you In forum General discussion, announcements and releases |
2 years temu |
|
OK - I'll try all that at the end of the workday 🙂 In forum General discussion, announcements and releases |
2 years temu |
|
It really didn't get far enough in the test to start adjusti... In forum General discussion, announcements and releases |
2 years temu |
|
I can give that a try too In forum General discussion, announcements and releases |
2 years temu |
