Prusa3D Forum

Notifications

Clear all

jay.n

Groupe: Enregistré

A(ont) rejoint: 2017/12/15

Active Member

	If you have a pair of very fine bent needle-nose pliers you ... Dans le forum Others (Archive)	il y a 7 years
	The filament should be inside the ptfe tubing right? As far... Dans le forum Others (Archive)	il y a 7 years
	I now have my hotend out! The tube had enlarged in the idler... Dans le forum Others (Archive)	il y a 7 years
	I have almost got the hotend out, but it is stuck now. I bel... Dans le forum Others (Archive)	il y a 7 years
	I finally removed the Extruder Cover. I had to remove the ho... Dans le forum Others (Archive)	il y a 7 years
	Chris, I have done the steps to remove the parts to get to ... Dans le forum Others (Archive)	il y a 7 years
	It looks like the leakage is blue (the previous color I used... Dans le forum Others (Archive)	il y a 7 years
	if it is coming around the nozzle it is not tightened enough... Dans le forum Others (Archive)	il y a 7 years
	I also hear a clicking noise when I try to insert my filamen... Dans le forum Others (Archive)	il y a 7 years
	hi * this is my contribution to this topic :-). I tried to... Dans le forum Improvements (Archive)	il y a 7 years
	Yes! I got my assembled MK3 today! It was a rather large pac... Dans le forum General discussion, announcements and releases	il y a 7 years
	Currently I'm learning Fusion 360. I'm using Simplify3D as a... Dans le forum Others (Archive)	il y a 7 years

Statistiques du forum

565 Forums

64.1 K Sujets

449.1 K Messages

18 En-ligne

70.2 K Membres

Icones du forum: Le forum ne contient pas de messages non lus Le forum contient des messages non lus

Icones du sujet: Sans réponse Repondu Actifs Au top Épinglé Non approuvé Résolu Privé Fermé