Prusa3D Forum

Notifications

Clear all

Jaxel

Groupe: Enregistré

A(ont) rejoint: 2019/02/12

Active Member

	Can I easily print in PETG, using a PLA gcode? Dans le forum How do I print this? (Printing help)	il y a 4 years
	I made the STL in tinkercad. I have the source. What would I... Dans le forum How do I print this? (Printing help)	il y a 6 years
	I have the STL... making it into a single object doesn't mak... Dans le forum How do I print this? (Printing help)	il y a 6 years
	Can't figure how to get my top layers to print evenly... Dans le forum How do I print this? (Printing help)	il y a 6 years
	It's the smallest bolt in the kit... Dans le forum Assembly and first prints troubleshooting	il y a 6 years
	Pre-Print calibration destroys hot-end wires... Dans le forum Assembly and first prints troubleshooting	il y a 6 years
	So I took the printer apart. Sprayed White Lithium in all th... Dans le forum Assembly and first prints troubleshooting	il y a 6 years
	No balls came out. I did not add any lubricant, and the prin... Dans le forum Assembly and first prints troubleshooting	il y a 6 years
	X Axis is way too loud? Dans le forum Assembly and first prints troubleshooting	il y a 6 years

Statistiques du forum

566 Forums

63.2 K Sujets

444.5 K Messages

20 En-ligne

68.2 K Membres

Icones du forum: Le forum ne contient pas de messages non lus Le forum contient des messages non lus

Icones du sujet: Sans réponse Repondu Actifs Au top Épinglé Non approuvé Résolu Privé Fermé