Notifications
Clear all
Jason
Group: Registered
Joined: 2020/12/18
Active Member
1
Print stopped with no error | 20 hours ago | |
Ok, I have started seeing this now. I built the lack(?) enc... | 1 day ago | |
Adding to Collections | 1 year ago | |
ok, wiped it down again, then let it sit, then poured dishso... | 4 years ago | |
Ok, ran it and it came out fine (pre-heat was low, but went ... | 4 years ago | |
@joantabb I was about to start the test with the PLA print o... | 4 years ago | |
prints come off after several layers | 4 years ago | |
You are right, they did give me some parts for the MK3. The... | 4 years ago | |
X-End-Motor Assembly wrong part? | 4 years ago |