|
I found it and the issue. The heat block is clogged and I c... In forum Hardware, firmware and software help |
9 months ago |
|
I did follow the instructions above. is it possible that th... In forum Hardware, firmware and software help |
9 months ago |
|
Ok, I thought I tightened it enough and yet, it is still hap... In forum Hardware, firmware and software help |
10 months ago |
|
Ok it does seem that this was the issue... maybe I did not ... In forum Hardware, firmware and software help |
10 months ago |
|
Will check that this weekend. Why would this only be happen... In forum Hardware, firmware and software help |
10 months ago |
|
Ok, baked my filament for over 12 hours. I took pictures of... In forum Hardware, firmware and software help |
10 months ago |
|
Odd problem with 1 type of PETG In forum Hardware, firmware and software help |
10 months ago |
|
So I think the issue is tension (what is making the false cr... In forum How do I print this? (Printing help) |
11 months ago |
|
Print stopped with no error In forum How do I print this? (Printing help) |
11 months ago |
|
Ok, I have started seeing this now. I built the lack(?) enc... In forum Assembly and first prints troubleshooting |
11 months ago |
|
Adding to Collections In forum General discussion, announcements and releases |
2 years ago |
|
ok, wiped it down again, then let it sit, then poured dishso... In forum Assembly and first prints troubleshooting |
5 years ago |
|
Ok, ran it and it came out fine (pre-heat was low, but went ... In forum Assembly and first prints troubleshooting |
5 years ago |
|
@joantabb I was about to start the test with the PLA print o... In forum Assembly and first prints troubleshooting |
5 years ago |
|
prints come off after several layers In forum Assembly and first prints troubleshooting |
5 years ago |
|
You are right, they did give me some parts for the MK3. The... In forum Assembly and first prints troubleshooting |
5 years ago |
|
X-End-Motor Assembly wrong part? In forum Assembly and first prints troubleshooting |
5 years ago |
