Prusa3D Forum

Notifications

Clear all

james.o7

Skupina: Registrovaný

Přidal se: 2017/02/06

Active Member

	I find its hard to get a good surface finish with PTEG. Mig... In forum How do I print this? (Printing help)	před 6 years
	Terrible Support interface Underside In forum How do I print this? (Printing help)	před 6 years
	nozzle dipping/scratching after print In forum Print tips (Archive)	před 7 years
	Yes I sliced both models. for PRUSA I sliced in SLIC3R. Th... In forum Print tips (Archive)	před 7 years
	[/img] In forum Print tips (Archive)	před 7 years
	Horiz. line in 3D Benchy Test In forum Print tips (Archive)	před 7 years
	Poor Domes/hemispheres In forum Print tips (Archive)	před 8 years
	I had to increase the X-axis height to 100mm. I believe the... In forum Print tips (Archive)	před 8 years
	SLIC3R In forum Print tips (Archive)	před 8 years
	I unfortunately over-wrote the Gcode, but these are get tips... In forum Print tips (Archive)	před 8 years
	I would make sure it has lots of slots and openings for air,... In forum Print tips (Archive)	před 8 years
	interesting....it was my own part and slice. I'll re-slic... In forum Print tips (Archive)	před 8 years
	how hot will this enclosure get? You have to worry about ... In forum Print tips (Archive)	před 8 years
	Sequential Pritning In forum Print tips (Archive)	před 8 years
	Printer Freezes-no clue why? In forum Print tips (Archive)	před 8 years

Fórum Statistiky

565 Fóra

64.5 K Témata

451.8 K Příspěvky

26 Online

71.1 K Uživatelé

Forum Icons: Forum contains no unread posts Forum contains unread posts

Topic Icons: Not Replied Replied Active Hot Sticky Unapproved Solved Private Closed