Prusa3D Forum

Notifications

Clear all

james.o7

Group: Registered

Joined: 2017/02/06

Active Member

	I find its hard to get a good surface finish with PTEG. Mig... In forum How do I print this? (Printing help)	6 years ago
	Terrible Support interface Underside In forum How do I print this? (Printing help)	6 years ago
	nozzle dipping/scratching after print In forum Print tips (Archive)	7 years ago
	Yes I sliced both models. for PRUSA I sliced in SLIC3R. Th... In forum Print tips (Archive)	7 years ago
	[/img] In forum Print tips (Archive)	7 years ago
	Horiz. line in 3D Benchy Test In forum Print tips (Archive)	7 years ago
	Poor Domes/hemispheres In forum Print tips (Archive)	7 years ago
	I had to increase the X-axis height to 100mm. I believe the... In forum Print tips (Archive)	8 years ago
	SLIC3R In forum Print tips (Archive)	8 years ago
	I unfortunately over-wrote the Gcode, but these are get tips... In forum Print tips (Archive)	8 years ago
	I would make sure it has lots of slots and openings for air,... In forum Print tips (Archive)	8 years ago
	interesting....it was my own part and slice. I'll re-slic... In forum Print tips (Archive)	8 years ago
	how hot will this enclosure get? You have to worry about ... In forum Print tips (Archive)	8 years ago
	Sequential Pritning In forum Print tips (Archive)	8 years ago
	Printer Freezes-no clue why? In forum Print tips (Archive)	8 years ago

Forum Statistics

559 Forums

62.9 K Topics

442.7 K Posts

18 Online

67.6 K Members

Forum Icons: Forum contains no unread posts Forum contains unread posts

Topic Icons: Not Replied Replied Active Hot Sticky Unapproved Solved Private Closed