Notifications
Clear all
James Doty
Grupa: Zarejestrowany
Dołączył: 2024/04/01
Active Member
1
| I'm a happy guy. My left z stepper motor arrived this mornin... | 2 years temu | |
| After spending time in chat with Prusa tech support it was d... | 2 years temu | |
| I've been on chat with Prusa tech support for about two hour... | 2 years temu | |
| Z axis won't line up | 2 years temu | |
| Could it be a sensitivity issue with my load cell sensor? I... | 2 years temu | |
| That's very helpful. Any idea how much difference is allow... | 2 years temu | |
| Nozzle clean fails every time, using PLA | 2 years temu |