james.c10 – Activité – Prusa3D Forum

Notifications

Clear all

james.c10

Groupe: Enregistré

A(ont) rejoint: 2017/02/24

Eminent Member

	Are you having these issue when you try and print the suppli... Dans le forum Prusa i3 kit (Archive)	il y a 8 years
	I had the same thing happen with my kit after about 1 week o... Dans le forum Others (Archive)	il y a 8 years
	Once I repositioned the sensor on the bed I used a silver pe... Dans le forum Others (Archive)	il y a 8 years
	It sounds like the probe has moved up (away from the bed) al... Dans le forum Prusa i3 kit (Archive)	il y a 8 years
	This happened on my printer as well. Through normal movemen... Dans le forum Others (Archive)	il y a 8 years
	Double check that the temperature sensor on the bottom of th... Dans le forum Prusa i3 kit (Archive)	il y a 8 years
	Antonio, Are you printing at 190 with the PRUSA filament? ... Dans le forum Prusa i3 kit (Archive)	il y a 8 years
	I had a rough appearance and some stringing on the frog when... Dans le forum Others (Archive)	il y a 8 years
	One thing you can check for next time is to print a temperat... Dans le forum Others (Archive)	il y a 8 years
	Jeff's suggestion of PID tuning the hot end is spot on. I p... Dans le forum Others (Archive)	il y a 8 years
	Ordered an orange kit on Feb 24th and got my tracking number... Dans le forum General discussion, announcements and releases	il y a 8 years
	Just an update: I ordered on an orange printer with the mul... Dans le forum General discussion, announcements and releases	il y a 8 years
	What about printing a small throw away tower next to the mai... Dans le forum Software (Archive)	il y a 8 years

Page 2 / 2 Précédent

Statistiques du forum

565 Forums

64.1 K Sujets

448.9 K Messages

18 En-ligne

70.2 K Membres

Icones du forum: Le forum ne contient pas de messages non lus Le forum contient des messages non lus

Icones du sujet: Sans réponse Repondu Actifs Au top Épinglé Non approuvé Résolu Privé Fermé