Notifications
Clear all
jaddel
Skupina: Registrovaný
Přidal se: 2021/09/01
Active Member
1
|
I'd also be interested. 🙂 In forum Awesome prints (Hall Of Fame) |
před 2 years | |
| I haven't tried the squash ball feet because didn't wanted t... | před 4 years | |
| This sound's ok to me, but you should use some vibrations da... | před 4 years | |
|
M18 S10 The steppers are still warm after a few hours. :/ In forum Hardware, firmware and software help |
před 4 years | |
|
The gcode commands M18 and M84 don't do anything. The z step... In forum Hardware, firmware and software help |
před 4 years | |
|
thx, I think I already tried M84 which didn't do anything an... In forum Hardware, firmware and software help |
před 4 years | |
|
[MK3S+] Z Axis Steppers stay on and get warm when the printe... In forum Hardware, firmware and software help |
před 4 years | |
| I bought the Drylins and gave them a try but for my taste th... | před 4 years | |
| Thanks for your reply. I think the bearings and y motor is d... | před 4 years | |
| MK3S+ is incredibly loud / noisy | před 4 years |