Notifications
Clear all
J.Roberts
J.Roberts
Group: Registered
Joined: 2023/07/11
Active Member
1
Agreed. Prusa has a chronic issue in this regard. This occur...

In forum General discussion, announcements and releases

2 months ago
The only real issue to contend with in any placement choices...

In forum User mods, enclosures, nozzles, ...

5 months ago
Rotating MMU3 idler on command

In forum General discussion, announcements and releases

6 months ago
Also ordered 7/27/2023 and my order status has also not chan...

In forum General discussion, announcements and releases

8 months ago
Is this true? Where is the official announcement? Did anyone...

In forum General discussion, announcements and releases

1 year ago
I also ordered on July 27, no estimated delivery date.

In forum General discussion, announcements and releases

1 year ago
You experienced a Hard Fault on 5.0.0.-RC? ...then update to...

In forum Hardware, firmware and software help

1 year ago
Yes grid infill is an issue. I also witnessed audible collis...

In forum Input Shaper (MK4)

1 year ago
Lets try this way : MK4IS - PETG grid infill - 0.20mm SPEE...

In forum General discussion, announcements and releases

1 year ago
I havent use this gallery image approach so I hope it works ...

In forum General discussion, announcements and releases

1 year ago
I have seen grid infill quality issues on MK4 as well when u...

In forum General discussion, announcements and releases

1 year ago
You can compare profiles and see the differentials within Pr...

In forum Input Shaper (MK4)

1 year ago
I think Ill give this a try too. May crack it open and see i...

In forum General discussion, announcements and releases

1 year ago
MMU3 Assembly manual

In forum General discussion, announcements and releases

1 year ago
FYI, this isa bit late but I believe some were having issues...

In forum User mods - OctoPrint, enclosures, nozzles, ...

1 year ago
FYI you can also use OrangePi with Octoprint.

In forum General discussion, announcements and releases

1 year ago
Share: