Prusa3D Forum

Notifications

Clear all

Incremental.Designs.G91

Groupe: Enregistré

A(ont) rejoint: 2020/05/25

Active Member

	I've done some testing over the last few months and I am 100... Dans le forum How do I print this? (Printing help)	il y a 3 years
	@bogdanh I like the way you are thinking but I forgot to a... Dans le forum How do I print this? (Printing help)	il y a 3 years
	I think what could be happening is that it looks over extrud... Dans le forum How do I print this? (Printing help)	il y a 3 years
	Weird extrusion artifacts on 45 happening, sometimes Dans le forum How do I print this? (Printing help)	il y a 3 years
	The MK3S has its strengths over the Mini but the Mini has so... Dans le forum General discussion, announcements and releases	il y a 4 years
	Would the Bondtech Dual Drive Extruder help with Inconsisten... Dans le forum User mods - OctoPrint, enclosures, nozzles, ...	il y a 4 years
	I was able to get it to work. After printing 6 cubes.. An E... Dans le forum Hardware, firmware and software help	il y a 4 years
	@joantabb Unfortunately I do not have a scale accurate enoug... Dans le forum Hardware, firmware and software help	il y a 4 years
	Are you sure about the 0.0013mm change? A 0.03 increase on ... Dans le forum Hardware, firmware and software help	il y a 4 years
	Extrusion Multiplier setting has no effect Dans le forum Hardware, firmware and software help	il y a 4 years

Statistiques du forum

559 Forums

62.8 K Sujets

442.4 K Messages

18 En-ligne

67.4 K Membres

Icones du forum: Le forum ne contient pas de messages non lus Le forum contient des messages non lus

Icones du sujet: Sans réponse Repondu Actifs Au top Épinglé Non approuvé Résolu Privé Fermé