Čeština
Fóra
Uživatelé
ibn
Aktivita
 
Notifications
Clear all
ibn
ibn
Skupina: Registrovaný
Přidal se: 2017/09/21
Trusted Member
3
Profile Aktivita
just saw the "load generic..." option (in the "settings..." ...

In forum Others (Archive)

 před 7 years
When openings are too small/narrow slic3r (and S3D too it se...

In forum Others (Archive)

 před 7 years
is your y-axis pulley secured firmly on the motor? One of th...

In forum Others (Archive)

 před 7 years
which version of the firmware are you currently using? I'm a...

In forum Others (Archive)

 před 7 years
Julien, does the manual preheat work? I couldn't find it in...

In forum Hardware, firmware and software help

 před 7 years
the slot was used as an easy way to actually strengthen the ...

In forum Others (Archive)

 před 7 years
Did you activate your filament sensor in the settings? It's ...

In forum Others (Archive)

 před 7 years
is the bondtech gear ont he extruder motor centered to the f...

In forum Others (Archive)

 před 7 years
the z-calibration is only for the fist layer, the height of ...

In forum Others (Archive)

 před 7 years
did you change the material (or sliced with the setting for ...

In forum Others (Archive)

 před 7 years
I printed this arm as well and observed the same lack of cle...

In forum Others (Archive)

 před 7 years
Does anyone know what this "residue" that helps us with prin...

In forum Others (Archive)

 před 7 years
I found this one, 17,7 mm in lengtht: I ordered more tha...

In forum Others (Archive)

 před 7 years
according to the manual in the settings (see pg. 30 f or pg....

In forum Others (Archive)

 před 7 years
looks like there's a filter in place currently, not sure abo...

In forum General discussion, announcements and releases

 před 7 years
which version of the firmware are you using? this is from ...

In forum Others (Archive)

 před 7 years
How about the stepper motors, what's the max advisable opera...

In forum Others (Archive)

 před 7 years
Stránka 3 / 3
Share: