Prusa3D Forum

Notifications

Clear all

iainmalcolm1

Groupe: Enregistré

A(ont) rejoint: 2018/04/26

Active Member

	I've had this problem where prints have a large solid base, ... Dans le forum General discussion, announcements and releases	il y a 10 months
	Once the print gets past the first X, and even more so once ... Dans le forum General discussion, announcements and releases	il y a 10 months
	Ah! that's useful - checked the gcode - it is fine, and rece... Dans le forum General discussion, announcements and releases	il y a 10 months
	glitched 20 hours into print - random or problem with gcode? Dans le forum General discussion, announcements and releases	il y a 10 months
	Seems like you’re trying to print on air. Physics won’t let ... Dans le forum How do I print this? (Printing help)	il y a 6 years
	You could also add a 45° chamfer to this edges. They would m... Dans le forum How do I print this? (Printing help)	il y a 6 years
	problem with partly detached ledge inside cylinder Dans le forum How do I print this? (Printing help)	il y a 6 years
	prusacontrol on linux (debian / ubuntu) Dans le forum Hardware, firmware and software help	il y a 6 years

Statistiques du forum

559 Forums

63.1 K Sujets

443.9 K Messages

22 En-ligne

68.1 K Membres

Icones du forum: Le forum ne contient pas de messages non lus Le forum contient des messages non lus

Icones du sujet: Sans réponse Repondu Actifs Au top Épinglé Non approuvé Résolu Privé Fermé