English
Forums
Members
hyiger
Activity
 
Notifications
Clear all
hyiger
hyiger
Group: Registered
Joined: 2025/07/14
Honorable Member
1
Profile Activity
I can only get a decent print on one side of the sheet. For ...

In forum Assembly and first prints troubleshooting

 2 months ago
Usually (and in my case) the Y motor was already grounded. C...

In forum Hardware, firmware and software help

 3 months ago
Try a different memory stick. The ones supplied by Prusa see...

In forum Hardware, firmware and software help

 3 months ago
Same problem, did many prints successfully until I tried one...

In forum Hardware, firmware and software help

 3 months ago
First week using Core One, lots of issues. Some tips for peo...

In forum Hardware, firmware and software help

 3 months ago
I asked the same of Prusa tech support and they replied with...

In forum Hardware, firmware and software help

 3 months ago
Problem with brand new Prusa Satin plate

In forum Assembly and first prints troubleshooting

 3 months ago
Thanks. I was in expert mode but neglected to scroll down. I...

In forum Assembly and first prints troubleshooting

 3 months ago
When changing colors mid-print, the filament oozes out of no...

In forum Assembly and first prints troubleshooting

 3 months ago
It's a brand new sheet from Prusa and I've only done 2 print...

In forum Assembly and first prints troubleshooting

 3 months ago
Upgraded my MK4S to Core One and getting waves in the first ...

In forum Assembly and first prints troubleshooting

 3 months ago
I went with gluing them on with Gorilla Glue Clear Grip. Bon...

In forum Assembly and first prints troubleshooting

 3 months ago
Yup, it was only a fluke. Adding the gcode patch worked for ...

In forum Assembly and first prints troubleshooting

 3 months ago
I completed the MK4S to CORE ONE conversion with 6.3.3 firmw...

In forum Assembly and first prints troubleshooting

 3 months ago
Page 28 / 28
Share: