Prusa3D Forum

Notifications

Clear all

HopelessDiamond

Skupina: Registrovaný

Přidal se: 2022/01/10

Active Member

	Well, in typical fashion, now that I've posted about the pro... In forum Hardware, firmware and software help	před 4 years
	This is some other problem prints, bottom and top. There's ... In forum Hardware, firmware and software help	před 4 years
	top and bottom of z calibration. Actually looks good to my n... In forum Hardware, firmware and software help	před 4 years
	Figured I'd do everything to start from a clean slate. What... In forum Hardware, firmware and software help	před 4 years
	Yeah, I've been trying to keep it clean and had washed it re... In forum Hardware, firmware and software help	před 4 years
	Struggling to get things to print, z-offset calibrated, then... In forum Hardware, firmware and software help	před 4 years

Fórum Statistiky

585 Fóra

68.1 K Témata

477 K Příspěvky

12 Online

75.8 K Uživatelé

Forum Icons: Forum contains no unread posts Forum contains unread posts

Topic Icons: Not Replied Replied Active Hot Sticky Unapproved Solved Private Closed