Prusa3D Forum

Avisos

Vaciar todo

Hoodwinx

Grupo: Registrado

Registrado: 2017/05/30

Active Member

	Looks like you could go a little closer and clean your bed a... En el foro Hardware, firmware and software help	hace 6 years
	Here is a photo showing my worst tube and a new one. En el foro Hardware, firmware and software help	hace 6 years
	Easier than expected. The issue was completely un-related to... En el foro Hardware, firmware and software help	hace 6 years
	I went ahead and did this last night on 4 of my machines. I ... En el foro Hardware, firmware and software help	hace 6 years
	Is this something the two of you use? I have never seen thi... En el foro Hardware, firmware and software help	hace 6 years
	MK3 PTFE Tube Pulling Out En el foro Hardware, firmware and software help	hace 6 years
	I tried printing your GCODE and it just stopped about 6 hour... En el foro Others (Archive)	hace 7 years
	They released an updated spool holder that is injection mold... En el foro Others (Archive)	hace 7 years
	It’s nice to see your succes with BVOH. I have done some rea... En el foro Others (Archive)	hace 7 years
	+1 En el foro Others (Archive)	hace 7 years
	Very interesting read. Thanks for doing the homework and rep... En el foro Others (Archive)	hace 7 years

Estadísticas del Foro

559 Foros

62.9 K Temas

442.8 K Respuestas

20 En línea

67.7 K Miembros

Iconos del foro: El foro no contiene publicaciones sin leer El foro contiene publicaciones sin leer

Iconos de los Temas: No respondidos Respondido Activo Popular Fijo No aprobados Resuelto Privado Cerrado