Prusa3D Forum

Notifications

Clear all

Hoodwinx

Group: Registered

Joined: 2017/05/30

Active Member

	Looks like you could go a little closer and clean your bed a... In forum Hardware, firmware and software help	6 years ago
	Here is a photo showing my worst tube and a new one. In forum Hardware, firmware and software help	6 years ago
	Easier than expected. The issue was completely un-related to... In forum Hardware, firmware and software help	6 years ago
	I went ahead and did this last night on 4 of my machines. I ... In forum Hardware, firmware and software help	6 years ago
	Is this something the two of you use? I have never seen thi... In forum Hardware, firmware and software help	6 years ago
	MK3 PTFE Tube Pulling Out In forum Hardware, firmware and software help	6 years ago
	I tried printing your GCODE and it just stopped about 6 hour... In forum Others (Archive)	7 years ago
	They released an updated spool holder that is injection mold... In forum Others (Archive)	7 years ago
	It’s nice to see your succes with BVOH. I have done some rea... In forum Others (Archive)	7 years ago
	+1 In forum Others (Archive)	7 years ago
	Very interesting read. Thanks for doing the homework and rep... In forum Others (Archive)	7 years ago

Forum Statistics

559 Forums

62.9 K Topics

442.8 K Posts

18 Online

67.6 K Members

Forum Icons: Forum contains no unread posts Forum contains unread posts

Topic Icons: Not Replied Replied Active Hot Sticky Unapproved Solved Private Closed