Prusa3D Forum

Notifications

Clear all

Høgge

Skupina: Registrovaný

Přidal se: 2017/06/29

Active Member

	@neophyl Nice, that someone (you) can help when Prusa insist... In forum PrusaSlicer	před 3 years
	@vojtech-bubnik So - is this going to be "fixed". I use Prus... In forum PrusaSlicer	před 3 years
	Hi, Did you solve the problem? I have the same with firmwar... In forum Hardware, firmware and software help	před 6 years
	Would be great if you would fix the broken serial communicat... In forum Hardware, firmware and software help	před 7 years
	Please fix the MK2 firmware serial comm issue ASAP - Octopi In forum Others (Archive)	před 7 years
	Well, export config bundle does not seem to export the setti... In forum Software (Archive)	před 7 years
	Direct printing from Slic3r over serial / USB seems to work ... In forum Others (Archive)	před 7 years
	You certainly don't need this: M104 S0 ; turn off extruder ... In forum Others (Archive)	před 7 years
	So to incorporate what I found I will start prints like this... In forum Others (Archive)	před 7 years
	But then the G-code for the printer should do that and also ... In forum Others (Archive)	před 7 years
	Thanks. Sounds plausible. Is it "backed" by any solid eviden... In forum Others (Archive)	před 7 years
	Heating during z-calibration ok? In forum Others (Archive)	před 7 years

Fórum Statistiky

559 Fóra

63.1 K Témata

444 K Příspěvky

22 Online

68.1 K Uživatelé

Forum Icons: Forum contains no unread posts Forum contains unread posts

Topic Icons: Not Replied Replied Active Hot Sticky Unapproved Solved Private Closed