|
Until now, I was using Slic3r for generating gcode and then ... In forum Hardware, firmware and software help |
7 years temu |
|
I think that's normal. I'm currently printing PEL, set to 20... In forum Prusa i3 kit (Archive) |
7 years temu |
|
Sorry, was away for a while.
Yeah, it seems there isn't a s... In forum Prusa i3 kit (Archive) |
7 years temu |
|
I was led to believe that PrusaControl uses the same slicer ... In forum Hardware, firmware and software help |
7 years temu |
|
I'm quite happy with PrusaControl so far, especially since t... In forum Hardware, firmware and software help |
7 years temu |
|
Sorry, I thought the OSX download contains a setup file (lik... In forum Prusa i3 kit (Archive) |
7 years temu |
|
I think you've been looking at the wrong place, try this:
... In forum Prusa i3 kit (Archive) |
7 years temu |
|
I think you'll be good with using an ordinary machine oil. I... In forum Prusa i3 kit (Archive) |
7 years temu |
|
Not sure if this is a good approach or if I got lucky, but w... In forum Prusa i3 kit (Archive) |
7 years temu |
|
Changed Y bearings, can't get XY perpendicular anymore In forum Prusa i3 kit (Archive) |
7 years temu |
|
Also, make sure to double check your Live Z adjustment. If i... In forum Prusa i3 kit (Archive) |
8 years temu |
|
My first guess would have been some lose connector or broken... In forum Prusa i3 kit (Archive) |
8 years temu |
|
Fan stopped working mid-print, seems ok now In forum Prusa i3 kit (Archive) |
8 years temu |
|
Mine does the same. Replaced the bearings yesterday (made su... In forum Prusa i3 kit (Archive) |
8 years temu |
|
Should Y bearings grind on the rods a little? In forum Prusa i3 kit (Archive) |
8 years temu |
|
Looks like you did not enable support in the slicer options,... In forum Prusa i3 kit (Archive) |
8 years temu |
|
What caused this print failure (pics included)? In forum Prusa i3 kit (Archive) |
8 years temu |
