Prusa3D Forum

Notifications

Clear all

herkam

Skupina: Registrovaný

Přidal se: 2020/01/18

New Member

	Found the source of the problem I think. There is some play ... In forum Assembly and first prints troubleshooting	před 6 years
	It is not an axial offset of the gear that is the problem, i... In forum Assembly and first prints troubleshooting	před 6 years
	Bad alignment of PTFE tube to bondtech gears In forum Assembly and first prints troubleshooting	před 6 years

Fórum Statistiky

585 Fóra

67.9 K Témata

476.1 K Příspěvky

11 Online

75.5 K Uživatelé

Forum Icons: Forum contains no unread posts Forum contains unread posts

Topic Icons: Not Replied Replied Active Hot Sticky Unapproved Solved Private Closed