Prusa3D Forum

Notifications

Clear all

heink

Skupina: Registrovaný

Přidal se: 2021/12/15

New Member

	RE: Extruder pulley does not turn during calibration or prin... In forum Hardware, firmware and software help	před 3 years
	Could a filament sensor malfunction cause this? In forum Hardware, firmware and software help	před 3 years
	the shaft and pulley are tight and will only turn at load o... In forum Hardware, firmware and software help	před 3 years
	Extruder pulley does not turn during calibration or printing... In forum Hardware, firmware and software help	před 3 years

Fórum Statistiky

565 Fóra

64.1 K Témata

449.2 K Příspěvky

22 Online

70.3 K Uživatelé

Forum Icons: Forum contains no unread posts Forum contains unread posts

Topic Icons: Not Replied Replied Active Hot Sticky Unapproved Solved Private Closed