Notifications
Clear all
Hartwood
Skupina: Registrovaný
Přidal se: 2022/09/26
Active Member
1
| Thanks Neophyl I was set at -0.300 to start with. -0.400 was... | před 3 years | |
| Thanks. The LH side is -0.3 and I wound it up a bit from -0.... | před 3 years | |
| Thanks, JSW. I don't have any sign of cracking, but it is br... | před 3 years | |
| Think I may have it, many thanks to you. I had the z set to ... | před 3 years | |
| Thanks I did do a calibration with the new sheet just as dir... | před 3 years | |
| I think this is what you want. | před 3 years | |
| Found it Doh. | před 3 years | |
| Sorry but where is the first layer calibration? | před 3 years | |
| Thanks. I have included a pic of the part I have been workin... | před 3 years | |
| Thank for the quick response. The filament is Prusa's own so... | před 3 years | |
| Does PLA filament go off with age. | před 3 years |