Notifications
Clear all
harmlessVI
harmlessVI
Skupina: Registrovaný
Přidal se: 2023/01/01
Trusted Member
3
Yeah I used some a few months ago but it was in kinda bad co...

In forum Hardware, firmware and software help

před 2 years
Hatchbox PLA

In forum Hardware, firmware and software help

před 2 years
Yeah that's about what I had before as far as print quality ...

In forum Hardware, firmware and software help

před 2 years
Did really well till the last couple layers, still had some ...

In forum Hardware, firmware and software help

před 2 years
Turned out quite nice from what I can tell with the Prusa PL...

In forum Hardware, firmware and software help

před 2 years
Alright I will lower it a bit, currently attempting with som...

In forum Hardware, firmware and software help

před 2 years
Not great but that is what it did not changing anything, cur...

In forum Hardware, firmware and software help

před 2 years
If this first layer cal doesn't work I will try switching to...

In forum Hardware, firmware and software help

před 2 years
Filament is brand new, has only been out of package for like...

In forum Hardware, firmware and software help

před 2 years
yes indeed

In forum Hardware, firmware and software help

před 2 years
Print settings for that.  PXL_20230103_002954157.MP_....

In forum Hardware, firmware and software help

před 2 years
Worked pretty good until the last couple layers, not quite s...

In forum Hardware, firmware and software help

před 2 years
Did a few cold pulls, about to print test. I also tightened ...

In forum Hardware, firmware and software help

před 2 years
About to work on it

In forum Hardware, firmware and software help

před 2 years
Here is a first layer calibration, will try other stuff here...

In forum Hardware, firmware and software help

před 2 years
Alright, I don't think there is but I will keep an eye on it...

In forum Hardware, firmware and software help

před 2 years
I did yesterday to see if anything was wrong with it along w...

In forum Hardware, firmware and software help

před 2 years
Yep

In forum Hardware, firmware and software help

před 2 years
Here is what happened, ran it at 215c and 100 (default) spee...

In forum Hardware, firmware and software help

před 2 years
Profile picture error on forum

In forum General discussion, announcements and releases

před 2 years
Stránka 3 / 4
Share: