|
Yeah I used some a few months ago but it was in kinda bad co... In forum Hardware, firmware and software help |
2 years ago |
|
Hatchbox PLA In forum Hardware, firmware and software help |
2 years ago |
|
Yeah that's about what I had before as far as print quality ... In forum Hardware, firmware and software help |
2 years ago |
|
Did really well till the last couple layers, still had some ... In forum Hardware, firmware and software help |
2 years ago |
|
Turned out quite nice from what I can tell with the Prusa PL... In forum Hardware, firmware and software help |
2 years ago |
|
Alright I will lower it a bit, currently attempting with som... In forum Hardware, firmware and software help |
2 years ago |
|
Not great but that is what it did not changing anything, cur... In forum Hardware, firmware and software help |
2 years ago |
|
If this first layer cal doesn't work I will try switching to... In forum Hardware, firmware and software help |
2 years ago |
|
Filament is brand new, has only been out of package for like... In forum Hardware, firmware and software help |
2 years ago |
|
yes indeed In forum Hardware, firmware and software help |
2 years ago |
|
Print settings for that.
PXL_20230103_002954157.MP_.... In forum Hardware, firmware and software help |
2 years ago |
|
Worked pretty good until the last couple layers, not quite s... In forum Hardware, firmware and software help |
2 years ago |
|
Did a few cold pulls, about to print test. I also tightened ... In forum Hardware, firmware and software help |
2 years ago |
|
About to work on it In forum Hardware, firmware and software help |
2 years ago |
|
Here is a first layer calibration, will try other stuff here... In forum Hardware, firmware and software help |
2 years ago |
|
Alright, I don't think there is but I will keep an eye on it... In forum Hardware, firmware and software help |
2 years ago |
|
I did yesterday to see if anything was wrong with it along w... In forum Hardware, firmware and software help |
2 years ago |
|
Yep In forum Hardware, firmware and software help |
2 years ago |
|
Here is what happened, ran it at 215c and 100 (default) spee... In forum Hardware, firmware and software help |
2 years ago |
|
Profile picture error on forum In forum General discussion, announcements and releases |
2 years ago |
