Notifications
Clear all
haris
Group: Registered
Joined: 2020/05/24
Active Member
1
| ptfe jam | 4 years ago | |
| @neophyl that's great, thank you so much for all the info, w... | 4 years ago | |
| the seam is indeed set to "random" most part i print are cir... | 4 years ago | |
| surface spots | 4 years ago | |
| @tim-m30 indeed, fifty microns made a big diference, also 7x... | 4 years ago | |
| first layer | 4 years ago | |
| thank you @bobstro, that's realy helpfull | 4 years ago | |
| can you please confirm that this is the one you turned down... | 4 years ago | |
| solid infill vibrations | 4 years ago | |
| Y axis belt was indeed not optimally tensioned after tension... | 4 years ago | |
|
seams that position of the sensor was slightly off, so I end... In forum Hardware, firmware and software help |
4 years ago | |
| thank you @jsw, will start by checking the heatbeat belt sin... | 4 years ago | |
| repeating pattern | 4 years ago |