Notifications
Clear all
HackMonkey
HackMonkey
Group: Registered
Joined: 2017/09/22
Trusted Member
3
1. This will very by filament. Some are worse than others. K...

In forum Others (Archive)

7 years ago
Try bumping your temps, slowing way down, and make sure the ...

In forum How do I print this? (Printing help)

7 years ago
When new versions of Slic3r are installed, the old profiles ...

In forum Others (Archive)

7 years ago
Flashed the 3.1.2-RC1 firmware and have run a couple smaller...

In forum Others (Archive)

7 years ago
Only time I adjust Z is when switching filament types. I als...

In forum Others (Archive)

7 years ago
I have yet to experience any performance issues effecting pr...

In forum Others (Archive)

7 years ago
I have ran my MK3 with both an external Pi2 and a Zero. The ...

In forum Others (Archive)

7 years ago
Great i will test that preset soon, for Vases and 0% infill ...

In forum Others (Archive)

7 years ago
The .35mm FAST profile is still available in Slic3r PE, if y...

In forum Others (Archive)

7 years ago
Agreed, there are still many situations where .3mm is viable...

In forum Others (Archive)

7 years ago
I have been having great luck with PETG, using the stock set...

In forum Others (Archive)

7 years ago
I am in total agreement with the original poster! The MK3 is...

In forum Others (Archive)

7 years ago
I will totally echo the sentiment that forums tend to sway h...

In forum Others (Archive)

7 years ago
I was just reading a few days ago that Ethyl Acetate (finger...

In forum Prusa i3 kit (Archive)

7 years ago
It should work just fine. That is what I did, pulled a RPi 2...

In forum Others (Archive)

7 years ago
On big open areas, where the printer can really open up on s...

In forum Others (Archive)

7 years ago
I had great luck with eSun eFlex TPU (Shore A 87). I just sl...

In forum Others (Archive)

7 years ago
For the belts, check the handbook, section 13.4. When I ask...

In forum Others (Archive)

7 years ago
The defaults are pretty darn good! I was communicating with...

In forum Others (Archive)

7 years ago
Yes. This is the Pi Zero W connected directly to the Einsy o...

In forum Others (Archive)

7 years ago
Page 2 / 5
Share: