Prusa3D Forum

Notifications

Clear all

HA60_Design

Skupina: Registrovaný

Přidal se: 2023/06/15

Active Member

	.1mm on the X and .15mm in the Y. I’ve checked the belts (th... In forum How do I print this? (Printing help)	před 2 years
	I would say it does. I printed a standard calibration cube a... In forum How do I print this? (Printing help)	před 2 years
	How did you manage to get the MK4 running via Pronterface? I... In forum Hardware, firmware and software help	před 2 years
	Hi there, where is this located in Prusa Connect? I've tried... In forum Introduction & Instructions	před 2 years
	Thanks Tojik, I've sent an email and hopefully I'll be able ... In forum Introduction & Instructions	před 2 years
	Not sure why it's marked as solved as I cant see how it is. ... In forum Hardware, firmware and software help	před 2 years
	Glad you asked as I was just about too. I've tried hooking i... In forum Introduction & Instructions	před 2 years

Fórum Statistiky

585 Fóra

68.1 K Témata

477.2 K Příspěvky

11 Online

75.8 K Uživatelé

Forum Icons: Forum contains no unread posts Forum contains unread posts

Topic Icons: Not Replied Replied Active Hot Sticky Unapproved Solved Private Closed