Prusa3D Forum

Notifications

Clear all

gwshook

Groupe: Enregistré

A(ont) rejoint: 2020/09/04

Active Member

	@gordon-w I tried loosening those 3 grub screws... They bare... Dans le forum Hardware, firmware and software help	il y a 4 years
	@gordon-w So my understanding of this is the problem is the ... Dans le forum Hardware, firmware and software help	il y a 4 years
	How do you adjust the heatbreak? I tried adjusting the idler... Dans le forum Hardware, firmware and software help	il y a 4 years
	@joantabb I opened the door over the extractor gear and when... Dans le forum Hardware, firmware and software help	il y a 4 years
	@joantabb Its PLA+ from Inland, also their PLA as well. Run... Dans le forum Hardware, firmware and software help	il y a 4 years
	No Plastic from Nozzle Dans le forum Hardware, firmware and software help	il y a 4 years
	@neophyl Ok, will see if he can print it in resin. The dimen... Dans le forum PrusaSlicer	il y a 4 years
	@neophyl Would it help if I were to try and fill in the insi... Dans le forum PrusaSlicer	il y a 4 years
	@karl-herbert But will this affect the slicer and cut out pa... Dans le forum PrusaSlicer	il y a 4 years
	Slicer removing part of model Dans le forum PrusaSlicer	il y a 4 years

Statistiques du forum

566 Forums

63.2 K Sujets

444.4 K Messages

21 En-ligne

68.2 K Membres

Icones du forum: Le forum ne contient pas de messages non lus Le forum contient des messages non lus

Icones du sujet: Sans réponse Repondu Actifs Au top Épinglé Non approuvé Résolu Privé Fermé