Aktywność
 
Notifications
Clear all
gvandehy
gvandehy
Grupa: Zarejestrowany
Dołączył: 2023/09/24
Eminent Member
2
In case anyone else runs into a similar issue, I appear to h...

In forum Hardware, firmware and software help

1 month temu
Thanks for the observation! It was indeed off by nearly 3mm...

In forum Hardware, firmware and software help

2 months temu
Bed Leveling Failed [probing back-right corner]

In forum Hardware, firmware and software help

2 months temu
I'm wondering if it is a firmware bug. I didn't get this err...

In forum Hardware, firmware and software help

4 months temu
I understand the importance of the nozzles being clean and I...

In forum Hardware, firmware and software help

4 months temu
Screenshot of the error attached  94e824fe-pxl_2025053...

In forum Hardware, firmware and software help

4 months temu
Any chance tool 2 isn't heating up enough? I had a bad therm...

In forum Hardware, firmware and software help

4 months temu
nozzle doesn't appear to have round cross section error

In forum Hardware, firmware and software help

4 months temu
THANK YOU! Exactly what I was looking for. I thought I'd s...

In forum Hardware, firmware and software help

1 year temu
Change the angle of the bridging?

In forum Hardware, firmware and software help

1 year temu
I'll have to give that a try. I didn't realize you could se...

In forum Hardware, firmware and software help

2 years temu
Filament Change mid-print XL multi-tool [non-current extrude...

In forum Hardware, firmware and software help

2 years temu
Significant improvement. Still a small void, not perfect but...

In forum PrusaSlicer

2 years temu
Thanks for this! I am having an incredibly frustrating issu...

In forum PrusaSlicer

2 years temu
Thanks DD I re-seated the ribbon cable on the display end an...

In forum Hardware, firmware and software help

2 years temu
I'm new to pva and had one good print. 2 days later had lots...

In forum How do I print this? (Printing help)

2 years temu
Pixel's response is what should happen, however, I ran into ...

In forum Hardware, firmware and software help

2 years temu
I'm guessing you are talking about the extruder gear? Lookin...

In forum Hardware, firmware and software help

2 years temu
I'm starting to experience this as well. I found another th...

In forum Hardware, firmware and software help

2 years temu
Any update on this? After a couple hundred hours of use, my...

In forum Hardware, firmware and software help

2 years temu
Strona 1 / 2
Share: