|
In case anyone else runs into a similar issue, I appear to h... In forum Hardware, firmware and software help |
7 months ago |
|
Thanks for the observation! It was indeed off by nearly 3mm... In forum Hardware, firmware and software help |
7 months ago |
|
Bed Leveling Failed [probing back-right corner] In forum Hardware, firmware and software help |
7 months ago |
|
I'm wondering if it is a firmware bug. I didn't get this err... In forum Hardware, firmware and software help |
10 months ago |
|
I understand the importance of the nozzles being clean and I... In forum Hardware, firmware and software help |
10 months ago |
|
Screenshot of the error attached
94e824fe-pxl_2025053... In forum Hardware, firmware and software help |
10 months ago |
|
Any chance tool 2 isn't heating up enough? I had a bad therm... In forum Hardware, firmware and software help |
10 months ago |
|
nozzle doesn't appear to have round cross section error In forum Hardware, firmware and software help |
10 months ago |
|
THANK YOU! Exactly what I was looking for. I thought I'd s... In forum Hardware, firmware and software help |
2 years ago |
|
Change the angle of the bridging? In forum Hardware, firmware and software help |
2 years ago |
|
I'll have to give that a try. I didn't realize you could se... In forum Hardware, firmware and software help |
2 years ago |
|
Filament Change mid-print XL multi-tool [non-current extrude... In forum Hardware, firmware and software help |
2 years ago |
|
Significant improvement. Still a small void, not perfect but... In forum PrusaSlicer |
2 years ago |
|
Thanks for this! I am having an incredibly frustrating issu... In forum PrusaSlicer |
2 years ago |
|
Thanks DD I re-seated the ribbon cable on the display end an... In forum Hardware, firmware and software help |
2 years ago |
|
I'm new to pva and had one good print. 2 days later had lots... In forum How do I print this? (Printing help) |
2 years ago |
|
Pixel's response is what should happen, however, I ran into ... In forum Hardware, firmware and software help |
2 years ago |
|
I'm guessing you are talking about the extruder gear? Lookin... In forum Hardware, firmware and software help |
2 years ago |
|
I'm starting to experience this as well. I found another th... In forum Hardware, firmware and software help |
2 years ago |
|
Any update on this? After a couple hundred hours of use, my... In forum Hardware, firmware and software help |
2 years ago |
